NLC 13 Redundant Navigation Light Control Board

NLC13 Redundant navigation light control card is used to control redundant navigation lights on boats. In case of any malfunction that may occur in the navigation lights, it warns the user audibly and visually, and activates the backup navigation light, if any.

With simple calibrations made on the control card; You can select the control switch as a push button or a switch, operate it in a single-channel or backup lantern system, and easily use navigation lanterns with filament lamps or led technology by introducing them to the card.

High-tech semiconductors used in the control card; In case of any problem that may occur in the navigation light or light line, it eliminates troublesome situations such as cable burning or fuse blowing, and can be used safely in military applications.

By throttling the DC energy feeding the control card through the power supply (up to 8 V. !!), the dimming process required in military applications is carried out smoothly and safely. The system is microcontroller controlled and its assembly is fast and simple with its socket terminals and rail mounting box design.

– The system is microcontroller controlled and its assembly is quick and easy thanks to its socket terminals.

– 12V.DC. or 24V.DC. It can work with feeding.

– It gives audible and visual malfunction notification in case of break in the Lantern/Lantern line or short circuit.

– 1 card for 1 local navigation light, auxiliary navigation light can be connected

– Led or incandescent navigation light can be connected to the same board.

– There are panel warning led outputs showing the on/off/fault status of the lantern.

– It has the feature of being reminded that there is a malfunction in the lantern, unless the lantern is replaced.

– Panel warning leds and audible buzzer can be tested.

– There is a test that the backup navigation light system is active.

– The system can be controlled with a mini button or key switch.

TECHNICIAL SPECIFICATIONS

Supply Voltage: 12 VDC – 24 VDC

Minimum Load: 12 Volts = 0.3 watts 24 Volts = 0.6 watts

Maximum Load: 12 Volts = 40 watts 24 Volts = 60 watts

Panel Warning Leds and Buzzer Output Type: PNP Transistor & + plus output

Control Switch Type: Pushbutton (Spring) / Switch with Calibration (Permanent)

Flashlight Overload/Short circuit protection: Electronic + Programmatic

Dimensions: e.105 X b.115 X d.58 mm