AP 29 Universal Alarm Sensors Panel

AP 29 UNIVERSAL ALARM SENSORS PANEL ( NEW PRODUCT )

Boat, Caravan, Machinery, Device etc. 1-channel Universel Alarm Panel, designed as a warning unit for the sensors currently used in your vehicles or produced by our company, fuel & hydraulic oil & water tank bottom - top alarm sensors / waste water & dirty water & shower tank bottom - top alarm sensors / bilge sensors / porthole / All contact or voltage output sensors such as hatch & limit switch sensors can be connected and supervised. The panel makes warning systems with such sensors more useful. N.O. / N.C. You can introduce sensors with contact or + PLUS / - MINUS outputs to the card with different connection options or simply by calibrating, and you can use them as a manual back-up unit to Alarm Monitoring Systems installed with PLC.
- Audible buzzer warning can be silenced by pressing the push button. The LED warning, on the other hand, continues the visual warning until the warning signal of the sensor input is cut off. When the alarm is silenced due to the alarm reminder feature on the panel, the buzzer starts to sound active again after 5 minutes. (This feature can be enabled/disabled by calibration)
- In order to prevent the warning led inside the pushbutton from disturbing the eyes during night driving, alarm dimming (led extinguishing) can be made by pressing the pushbutton for 3 - 4 seconds after the buzzer is silenced at the time of the alarm. This dimming, if the alarm reminder is active, will be automatically canceled after 5 minutes or if the warning signal is cut off and again, and the warning led will be active again. ATTENTION !!! If you have darkened the alarm and the alarm reminder is not active, the led and buzzer will not be active until the warning signal is cut off and it comes back (ie, until a new alarm occurs). If you want to activate the warning led manually, you can cancel the alarm dimming by pressing the pushbutton for 3 - 4 seconds.
- To test the soundness of the warning led and buzzer on the alarm panel, push the pushbutton for 3 - 4 seconds when there is no alarm on the panel.

APPLICATION and USE

- With the excitation signal coming from the sensor, the panel warning led becomes active by giving a signal. When the excitation signal reaches 5 seconds, the buzzer starts to sound. (This delay is for turbulence)